Posts Tagged ‘design’
SandShark JR
January 13, 2011 | 
Author SandShark JR Anchor
The SandShark JR Anchor solves your sand bar, beach, or shallow water docking problems for your Boat, Jet Ski, PWC, or Dinghy.
-
Designed to store in most Jet Ski and PWC compartments.
-
Use as primary or secondary anchor for boats.
-
Use as a sand or beach spike.
How it works:
Here are step by step instructions on using the JR-the Ultimate Jet Ski and PWC Sand Anchor. The JR will store at 18″ in the front compartment of your watercraft and extend to 31″ to set the auger deep for safe, strong and effective holding power.
Easy to use and easy to store; the JR is the most effective sand and shallow water anchor for jet skis, PWC’s and waverunners.
 The JR in storage mode |
 Remove the Pins |
 Remove the auger and extension from the handle, |
 Insert extension and pin onto auger shaft. |
 Insert handle and pin onto extension. |
 Done! |
Reverse instructions to put the JR back in storage mode.
Relax and enjoy your time on the water without having to worry about your watercraft getting beached or drifting away with the tide! No need to beach it! Just dock it safely in shallow water close to the shore!
SandShark JR Features:
- Stores to 18″ inches. Fits in Most PWC’s and Jet Ski’s
- 31″ inches from Top to Bottom
- Constructed Completely out of Stainless Steel
- Lifetime Warranty, Top Quality and Built to Last
- 1/2″ inch Solid Stainless Steel Auger Shaft w/3” Blade
- Foam Grips for Comfortable Turning
- Quick Release Pin for Easy Use and Storage
- High Corrosion Resistance
- Proudly Made in the USA!
*NOTE FOR SALTWATER USAGE
Saltwater is one of the toughest environments for metals and if the salt remains on the anchors in storage it will continue to promote corrosion. Stainless steel has a high tolerance for corrosion but if left in saltwater long enough it too is susceptible. For best results and corrosion resistance please rinse the saltwater off the anchors when putting into storage or after use. If you have signs of corrosion use a wire brush or sandpaper to remove.
SandShark Jr. Update (Jet Ski version)
Still waiting on the final quotes for the SandShark Jr.. I have the prototype, just waiting to begin manufacturing. I was hoping to make the summer season in the US, but am unsure now. My best estimate is around September. We made a few design changes and I have to say it is really cool! There is not anything on the market this cool or effective for jet-skis. It fits in the front compartment of most jet-skis. We have had alot of request for this item because there are not may alternatives currently on the market. Especially ones that are effective at holding the jet-ski in place. We believe this will be a very “hot product” when it is released! Please leave you information if you would like us contact you when this becomes available. Thanks
